Sealed Garage Floors That Stand Up to Pittsburgh Winters
Winter in Pittsburgh means salt trucks, freeze-thaw cycles, and vehicles dripping melt water onto bare concrete. An epoxy, metallic or polyaspartic coating seals the slab, stops staining, and gives you a floor that wipes clean. We grind every slab before coating, because adhesion starts with prep, and every project includes a free written estimate.
How Surface Prep Determines If Your Epoxy Floor Lasts
A coating is only as good as the concrete underneath it. When a floor is sealed, dusty or has old sealer still clinging to it, a new coating cannot bond. It flakes and peels within months, usually in the tire tracks where the weight and heat are greatest.
We grind or shot-blast the slab to expose fresh concrete, fill any cracks or spalling, and test for moisture. Only then does the primer, body coat and topcoat go down, layer by layer, to the manufacturer's spec. The result is a coating that actually adheres.
From there, the choice is yours. Epoxy coatings offer proven durability at a fair price. Polyaspartic systems cure in a day and resist UV fading. Metallic epoxy creates a marbled, high-end look. We also offer polished concrete for a sealed, low-sheen finish without any coating.
Recent work
The sequence
Step-by-Step: Installing a Garage Floor Coating
Inspect the slab for moisture and damage
We measure moisture levels, look for cracks, pits and old sealers, and determine which coating system fits your use and timeline.
Grind or shot-blast the concrete
Mechanical grinding opens the slab surface and removes dust, old sealer and contaminants so the new coating can bond properly.
Repair cracks and fill pits
We patch any damage with concrete repair compound so the finished surface is smooth and the coating adheres uniformly.
Apply primer, body and topcoat
The full coating system goes down in layers, with flake or metallic pigment if chosen, cured between coats per the product spec.
Cure and hand off
We walk the floor with you, confirm the finish, and give you the timeline for foot traffic, vehicles and care instructions.
System selection
Choosing the Right Coating System for Your Garage
Not every garage needs the same coating. Epoxy is the standard choice, delivering a tough, sealed, flake-finished surface at a reasonable cost. Polyaspartic costs more but cures in roughly a day and resists UV discoloration, so it stays vibrant through years of sunlight.
For a showroom appearance, metallic epoxy swirls pigment through the coating for a marbled effect. If you prefer no coating at all, polished concrete grinds the slab to a hard, sealed finish. When a previous coating has failed, garage floor repair strips it, re-grinds the slab and rebuilds the system correctly.
Coating systems, prep, cost and durability for a Pittsburgh garage floor.
Coatings peel when they are applied over an unprepared slab. We mechanically grind or shot-blast every floor to a clean profile and check for moisture first, so the coating bonds to sound concrete instead of dust or old sealer.
Epoxy is the proven, cost-effective workhorse. Polyaspartic costs more but cures in about a day and holds its colour under UV. We match the system to how the garage is used and your timeline.
Yes, when it is the right system on a properly prepped slab. Epoxy, metallic and polyaspartic coatings are built to resist de-icing salt, moisture and hot-tire pickup, which is exactly what a Pittsburgh garage throws at a floor.
Coatings generally run $4 to $9 per square foot depending on the system, the slab condition and how much repair the concrete needs first. We confirm it with a written, itemised quote after seeing the floor.
Yes. Garage floor repair strips the failed coating, re-profiles the slab, repairs the concrete and rebuilds the system properly so the new finish actually bonds and lasts.
Homeowner reviews
What Pittsburgh Homeowners Say About Their Garage Floors
Describe how you use the garage and we will recommend the right coating, grind the slab, and deliver a written, itemised quote with a firm finish date.
